So I've searched quite a bit on this and other forums for the answer for this. I'm going to swap my AJE K-Member and motor mounts out on my '79 Carb Turbo Pace Car. I'm not satisfied with the amount of engine vibration created. Unfortunately I no longer have my original Factory K-Member and mounts as I thought I would never need them again. I settled on a Maximum Motorsports K-Member that will accommodate a 2.3L. So now I need to find out what motor mounts I would need to use with the new MM K-Member. I need all parts that would be needed to attach the mount to the K-Member and engine. Right now the AJE K-Member uses a solid mount with a plate that attaches to the engine. I could not longer use this plate with the new MM K-Member. I found some mounts that look like they would attach to the MM K-Member but could not see how they would bolt up to the engine without an adapter of some sort. Is there a mount that would be all-inclusive and have everything needed from K-Member up to the engine itself? Or did I screw up not retrieving whatever was bolted to the engine and mount when I swapped the AJE K-Member in? Any assistance would be much appreciated.
Connect With Us