That's what I was afraid of. So with that being said, what would be the best way to address that? Let me rephrase that a bit......how would I address any small high spots? Surely it is not necessary to redo the whole area again since it is only a couple spots that I see. Can I hammer and dolly the small high spots then skim coat that area? Do I need to sand all the primer off the repair area or can I fill over that?
I wish I could have captured a good shot of what I can see, but it didn't translate through the lens again. I know it has to be darn close but I don't want to take the chance that it will stick out like a booger on a nose hair when I'm done, so I would rather try again than just accept it and hope it is not noticeable.
Connect With Us