Ok everyone, I got the spoiler on this morning. Here is how I went about it: There is a center hole in the spoiler, mine had 3 of the plastic push in holders (what are those things anyway?) I went from the center of the bumper cover, one of the lines in the bumper cover was a great reference. Note the push pin I was talking about in the center.
After that, I followed the holes in the spoiler itself, pushing and making flush as I drilled new holes, then just held it in with regular bolts, washers, and lock nuts from the local hardware store. As you start to get toward the side of the car, you need to trim about 2 1/2" off of the end of the spoiler or it will not clear the tire.
Place the spoiler back up on the car, and make a couple of slices in the spoiler to allow it to make the turn.
After all the triming is done, put it back on, make a few last minute trim adjustments, just to make it neat. Which for me ended up being about another 1 3/4" trim off of the end.
Here is the finished product, what do you think?
Connect With Us