Car - 1986 Mustang LX 3.8 v6 CFI, C5 Auto...converting to 5.0/t5/Holley Terminator X EFI
Long time listener first time caller here....
Doing a 5.0/T5 swap into an 86 v6 auto....Going with aftermarket EFI, so I've ripped harness from passenger side, now working on sorting out what I need to keep on driver side.
I'm trying to figure out the Start/NSS/Clutch/Reverse light situation, I've read you can just plug pigtails from auto car into clutch pedal but I dont think I have those in my early 86 built car, so likely need to build my own wire harness.
What I'm planning so far the following:
Reverse Lights - I have 4 wires going to the orig trans tunnel, I believe the Purple & Black wires are reverse lights, so buy a new plug for t5 trans and plug into side of trans.
NSS - the old NSS wire from auto, as part of the reverse light harness (Red/Light Blue loop together with White/Pink), I think I just loop those two together? I don't need the T5 NSS because the Holley EFI won't need that.
Clutch Switch - This is where I'm lost as to what is needed?
Thanks for any help.
Connect With Us