i come up with #12 metric,1.75 pitch
pinion flange.
tried one, wont go far...
?? anybody...
i come up with #12 metric,1.75 pitch
pinion flange.
tried one, wont go far...
?? anybody...
You are correct the 12mm with 1.75 thread pitch and a 12 point 12mm head is the standard OEM bolt for the 8.8 flange.
The dry thread lock, can make the bolts difficult to thread in by hand. Not sure if you are using a regular bolt or an OEM. Possible maybe someone cross threaded a hole in the flange?????
Of course like everything these days they are sold out, but would normally be a good replacement set for the OEM bolts. https://www.dennysdriveshaft.com/p35...rd_8.8_in.html
Trey
"I Don't build it hoping for your approval! I built it because it meets mine!"
"I've spent most of my money on Mustangs, racing, and women... the rest I just wasted."
Mustangs Past: Too many to remember!
Current Mustangs:
1969 Mach 1
1979 Pace Car now 5.0/5 speed
1982 GT Stalled RestoModification
1984 SVO Still Waiting Restoration
1986 GT Under going Wide Body Conversion Currently
Current Capris:
1981 Capri Roller
1981 Capri Black Magic Roller Basket Case
1982 Capri RS 5.0/4spd T-top Full Restoration Stalled in TX
1984 Capri RS T-top Roller
1983-84 Gloy Racing Trans Am/IMSA Body Parts
ok ill try again.
why 8 holes?...all the same ??
Two different bolt circle diameters. With your driveshaft, you can only use one of them.
Jack Hidley
Maximum Motorsports Tech Support
ok, makes sense...gotta find bolts,but have lots of time
Connect With Us