Hey all, now that my fuel line is all ran and hooked up I need to wire in my pump using a relay. I bought the painless fuel pump relay kit. It seems pretty straight forward but I do have some questions that hopefully someone who's done this can answer.
What's the best place to mount the relay? The pump is back by the spare tire well so easiest would be somewhere in the hatch area. Can I run the power wire that goes to battery along the fuel line or is that a no no?
Should I be running a inertia switch? If so where does that fit into the wiring?
I need to wire it to a switched 12v source, what's the best wire to tap into. This is my main concern.
I would like to incorporate a switch or a button that needs to be on before pump will prime. Will that be hooked up to the same wire that runs to the switched source?
Also car is a 84, did it have a inertia switch somewhere?
Sorry for all the questions lol electrical is not my cup of tea and I want to be sure I'm doing this right. Here is a pic of the diagram that comes with the wiring kit. Thanks
https://www.yumpu.com/en/document/re...n-instructions
Connect With Us