In the process of deleting the stock proportioning valve, I can't seem to find the correct fitting to adapt the 7/16-24 nut that's on the line out of the rear of the stock proportioning valve to the 3/8-24 brass T that's being installed to tie the front brake lines together. I have an adapter that's 7/16-24 female IF to 3/8" male IF, the issue I find with this is the line sizes are 1/4" and 3/16" respectively. Does anyone make an adapter of this flavor that's designed for 3/16" line on both sides?
I found this:
https://www.summitracing.com/parts/e...1erl/overview/
However, I'm concerned that the 7/16"-24 will once again be for 1/4" line.
I plan on going with a 94/95 Cobra M/C with a couple MM adapters that will allow 3/8-24 fittings, which will play nicely with my FMS adjustable proportioning valve.
Any assistance is greatly appreciated! Can this be done without cutting and reflaring?
Connect With Us