Close



Results 1 to 6 of 6

Thread: Rear Springs

  1. #1

    Default Rear Springs

    Hi All,
    I just picked up a set of aftermarket springs an need to know
    which way the rear pigtails go up or down.
    Thanks,
    ed

  2. #2

    Default

    Pigtails are down, in contact with the rear lower arm. Tail should point to the left, across the width of the car when looking at the rear facing forward.
    1985 GT owned since new

  3. #3
    Moderator wraithracing's Avatar
    Join Date
    Jun 2010
    Location
    Grand Junction, CO/RR TX
    Posts
    12,804

    Default

    Pigtails are at the back of the car and both sides point to the driver side of the vehicle. Both springs are installed the same way.
    ​Trey

    "I Don't build it hoping for your approval! I built it because it meets mine!"

    "I've spent most of my money on Mustangs, racing, and women... the rest I just wasted."

    Mustangs Past: Too many to remember!
    Current Mustangs:
    1969 Mach 1
    1979 Pace Car now 5.0/5 speed
    1982 GT Ongoing RestoModification
    1984 SVO Awaiting Restoration
    1986 GT Wrecked by PO, but still want to save!

    Current Capris:
    1981 Capri Roller
    1981 Capri Black Magic Roller Basket Case
    1982 Capri RS 5.0/4spd T-top Full Restoration Underway
    1984 Capri RS T-top Roller
    1983-84 Gloy Racing Trans Am/IMSA Body Parts

  4. #4

    Default

    Yeah, on second reading my description was not as clear as intended. The 'facing forward' was meant to apply to the observer, not the car. So in other words, 'stand behind the car and look at it'.
    1985 GT owned since new

  5. #5

    Default

    Thanks Guys,
    ed

  6. #6
    FEP Power Member qtrracer's Avatar
    Join Date
    Aug 2004
    Location
    Maryland
    Posts
    1,793

    Default

    FWIW, while Ford says point both pig tails in the same direction, you can fine tune ride height by moving the pig-tail around to different locations on the lower arm. For example if one side is slightly lower than the other moving the pigtail around to face the front on one side and the back on the other will change height on each side. There isn't much adjustment, but if you are looking for .25" moving the pig tail up or down on the arm will give some adjustment. I've also used a combo of isos (rubber and/or poly) to fine tune height both in the front and back.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •