My new engine is complete and been home awhile. Been working on all the suspension mods and hording parts for the car build out. Rear axle and tranny are next.
Question: Should I add oil and prime the motor so some oil is circulated through out as it is going to sit for a good 6 months until I'm even close to installing the drive line. I have the motor bagged and on an engine stand in a climate controlled shop with moisture bags setting in the lifter valley. I was thinking to prime it with my break in oil I will run for its first start up at the dyno shop just to prevent any rusting or parts setting dry.
Please advise best practice.
Connect With Us