i have found the sides but i need the strip across the rear bumper how sells these? thanks
i have found the sides but i need the strip across the rear bumper how sells these? thanks
I believe this was answered in another thread you started, but just in case . . . The body side molding on the front and rear bumper cover is part of the bumper cover assembly. The entire cover is molded as one piece and the rub strip/body side molding section is not removable or replaceable.
You will have to either replace the rear cover with a better quality unit or repair what you have. Standard urethane/plastic repair methods work just fine in most cases. High build primer and lots of sanding in addition to different urethane/plastic repair products/fillers will get the job done. Not a fun job, but what it takes quite often. I am doing the same to my 82 Capri RS both front and rear.
If you look for a replacement cover the 79-84 Mustangs and the 79-82 Capri have the one you need. Good Luck!
Trey
"I Don't build it hoping for your approval! I built it because it meets mine!"
"I've spent most of my money on Mustangs, racing, and women... the rest I just wasted."
Mustangs Past: Too many to remember!
Current Mustangs:
1969 Mach 1
1979 Pace Car now 5.0/5 speed
1982 GT Stalled RestoModification
1984 SVO Still Waiting Restoration
1986 GT Under going Wide Body Conversion Currently
Current Capris:
1981 Capri Roller
1981 Capri Black Magic Roller Basket Case
1982 Capri RS 5.0/4spd T-top Full Restoration Stalled in TX
1984 Capri RS T-top Roller
1983-84 Gloy Racing Trans Am/IMSA Body Parts
Connect With Us