Hello guys!
I hope all are doing well.
I am planning to upgrade my front 84 LX brakes to 87+ 11" rotors and calipers, I got all the parts required for the swap. I got Russell's front braided stainless brake hoses too.
The rear end was swapped from a 7.5 to an 8.8, but rear brake hard lines from the 7.5 were used, so my rear brake hose is a passenger side type OEM hose that was use for a single exhaust cars. So the Russell's rear hose will not fit.
Since I cannot find that specific (7.5) rear hose in stainless steel, i have ordered a new rubber one just to replace the old one.
Will I run into any problems using front stainless steel braided brake hoses with a new rubber rear brake hose? Will I gain any benefits from this set up?
Your help is greatly appreciated.
Connect With Us