Hey guys, I guess it’s been a while since I’ve been around this forum. It’s time to get the ol 85 a paint job. I found a lot of rust in the driver’s door, so I went to the pick n pull and picked up an immaculate door off of a 91 coupe. I swapped out all of the innards into the new door and installed it on the car today. The problem is it seems to be sagging about 1/4-1/2 inch. I put in new bushings and hinge pins, so that’s not the problem. My next step is likely to pull the fender and loosen the hinge bolts at the body and try to adjust it up that way. Anyone else run into a similar issue?