So, doing my conversion to MAF and one of my wires is missing the terminal end that plugs into the computer connector.
Are these just molex connector ends or are they something different?
thanks,
mike
So, doing my conversion to MAF and one of my wires is missing the terminal end that plugs into the computer connector.
Are these just molex connector ends or are they something different?
thanks,
mike
well to anyone wondering. The eec-iv terminal pins can be found by searching Dorman 85346(*edit* so I received the pins, but they are too large...so these are not the correct ones. I have ordered another set E7EB-14487-AA which will most likely work.) or CP-8793-F
Last edited by stangman86gt; 10-06-2018 at 07:57 PM. Reason: adding info
Sorry didn't see this post before. Here is another great option for replacement pigtails, etc.
https://www.motorcraft.com/content/d...-Book-2016.pdf
Trey
"I Don't build it hoping for your approval! I built it because it meets mine!"
"I've spent most of my money on Mustangs, racing, and women... the rest I just wasted."
Mustangs Past: Too many to remember!
Current Mustangs:
1969 Mach 1
1979 Pace Car now 5.0/5 speed
1982 GT Stalled RestoModification
1984 SVO Still Waiting Restoration
1986 GT Under going Wide Body Conversion Currently
Current Capris:
1981 Capri Roller
1981 Capri Black Magic Roller Basket Case
1982 Capri RS 5.0/4spd T-top Full Restoration Stalled in TX
1984 Capri RS T-top Roller
1983-84 Gloy Racing Trans Am/IMSA Body Parts
thanks for the wealth of info there(there's a lot hehe).
So, it did end up being E7EB-14487-AA and/or a18408-10
I ordered them from amazon, but they came from clipsandfasteners.com. So, that's another place to look for them.
good luck everyone!
Fast way is hit the junkyard and clip pigtails with pins on the end out of a junk car.
And a MAF plug
shrink tubes and solder is very helpful in putting things together.
i don't really live near enough to population to make it feasible to find a junkyard(will be over an hour drive to get to one hehe) and hope they have a car with an eec-iv i can clip, but yes that would be easiest if i did hehe
Are you in NorCal? I'm probably not too far from you over the border in Oregon. Sounds like you have a solution though.
Join The Conversation
http://www.youtube.com/basinmotorsports
'86 Hatchback V6 / Auto Restomod (For Sale)
yep.
There's disadvantages to not living near dense populations, but I'll take those over living in a populated area again. All the back roads that no one drives on, makes having a mustang fun to own around these parts =)
Connect With Us