Close



Results 1 to 8 of 8
  1. #1

    Default Main wiring harness question(86 gt)

    So, doing my conversion to MAF and one of my wires is missing the terminal end that plugs into the computer connector.

    Are these just molex connector ends or are they something different?

    thanks,
    mike

  2. #2

    Default

    well to anyone wondering. The eec-iv terminal pins can be found by searching Dorman 85346(*edit* so I received the pins, but they are too large...so these are not the correct ones. I have ordered another set E7EB-14487-AA which will most likely work.) or CP-8793-F
    Last edited by stangman86gt; 10-06-2018 at 07:57 PM. Reason: adding info

  3. #3
    Moderator wraithracing's Avatar
    Join Date
    Jun 2010
    Location
    Grand Junction, CO/RR TX
    Posts
    11,760

    Default

    Sorry didn't see this post before. Here is another great option for replacement pigtails, etc.

    https://www.motorcraft.com/content/d...-Book-2016.pdf
    ​Trey

    "I Don't build it hoping for your approval! I built it because it meets mine!"

    "I've spent most of my money on Mustangs, racing, and women... the rest I just wasted."

    Mustangs Past: Too many to remember!
    Current Mustangs:
    1969 Mach 1
    1979 Pace Car now 5.0/5 speed
    1982 GT Awaiting Restoration
    1984 SVO Restoration in Progress
    1986 GT Wrecked by PO, but still want to save!

    Current Capris:
    1982 Capri Roller
    1984 Capri Returned to Bubble Back Glory
    1983-84 Gloy Racing Trans Am/IMSA Body Parts
    1982 Capri RS 5.0 4spd T-tops

  4. #4

    Default

    thanks for the wealth of info there(there's a lot hehe).

    So, it did end up being E7EB-14487-AA and/or a18408-10

    I ordered them from amazon, but they came from clipsandfasteners.com. So, that's another place to look for them.

    good luck everyone!

  5. #5

    Default

    Fast way is hit the junkyard and clip pigtails with pins on the end out of a junk car.

    And a MAF plug

    shrink tubes and solder is very helpful in putting things together.

  6. #6

    Default

    i don't really live near enough to population to make it feasible to find a junkyard(will be over an hour drive to get to one hehe) and hope they have a car with an eec-iv i can clip, but yes that would be easiest if i did hehe

  7. #7

    Default

    Are you in NorCal? I'm probably not too far from you over the border in Oregon. Sounds like you have a solution though.

  8. #8

    Default

    yep.

    There's disadvantages to not living near dense populations, but I'll take those over living in a populated area again. All the back roads that no one drives on, makes having a mustang fun to own around these parts =)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •