After spending way too much time trying to decide on a set of valve covers for the 302, I decided on a set of the ProForm Black Ford Racing covers. I really like them, not too tall, but as with most any aftermarket parts these days, presents their own set of challenges for our engine.
First is the locations of the holes in the covers. Ours normally has a hole in the front on the pass side, and in the rear on the drivers, and these are opposite. Usually the oil filler neck is on the pass side, so I wondered if people had any good recommendations of a push-in oil filler tube for the pass side, or should I just run a push-in breather like the second and third pics below?
Now, usually on the drivers side, people install a push in breather, but as you can see from the pic, there is next to no room for almost anything on the drivers side, due to the intake manifold. Any idea what to run on the drivers side, or should I just plug it with one of the rubber grommets?
As always, thanks in advance... love this community of enthusiasts.
Connect With Us