I usually don't post much because I normally find the answer when searching. My first issue is the car stalls immediately when starting a few times whether it's cold or hot. I'm 99% sure my edelbrock 600cfm carb is set correctly and I'm unable to find any vacuum leaks. Could this be a distributor or ICM issue?


My second issue is I get a slight whine in 1,2,3 gears only when my foot is on the gas. I recently had it apart to replace input shaft bearing and I'm pretty sure preload was set correctly. I looked over everything else and to my eye the other bearings where fine.

If it was input shaft bearing or preload issue wouldn't it whine when revving in neutral?

Also I nicked a tooth on the input gear when cutting off the old inner race, could that cause a whine?

The only other thing I can think of is when I replaced heater core hoses i installed a socket as a restricting orifice for the inlet. Anybody do the same and result in a whine?

Thanks in advance, any information will be helpful.