So, I ended up getting a really good deal on an ported fuel injection manifold, large throttle body, BBK spacer, with harness, larger injectors, ecu, etc, etc. to install into my 1985 GT. I was going to just stick with a double pumper, but the deal I got was only about $100 more than the carb by itself, so in my opinion, it was worth it to just make the switch. I will still need a fuel pump, but that brings me to my questions.
My car came with the fuel tank in the rear hatch area, not installed in the car, and I wanted to post a pic and see if anyone can tell me if its a carbureted tank, or fuel injected tank. I believe that its the original tank, but not sure.
Next question is, can I just install a Walbro or whatever most would recommend, into this tank, or does the tank need to be swapped out? Which pump do most recommend, and I am guessing that a plat is just installed over where the factory engine mounted pump was?
Finally, I have found a couple threads with questions about doing this complete swap in an early fox body, but was wondering if anyone had a link they could share with a complete DIY?
As always, thanks in advance for you your advice.
Here is a pic of the tank:
Connect With Us