i'm looking to do essentially this with some autometer z series gauges:
http://www.flemworld.com/diy/gauges.html
the thing is autometer does not offer the speedometer and tach in 3-3/4" sizes i want. they do offer them in 3-3/8" though. has anyone else done this using 3-3/8" gauges? do they look too small?
normally i wouldn't ask, but this whole ordeal is going to cost close to $500 i don't really want to spend... but the inaccurate factory gauge cluster with its printed circuit board and cable driven speedometer just drew its last straw.
cale
Connect With Us