Close



Results 1 to 5 of 5
  1. #1
    FEP Senior Member 4EYED85's Avatar
    Join Date
    Mar 2012
    Location
    Round Rock, Tx
    Posts
    707

    Default Power Steering Help Please

    My rack, hoses, and pump are new. I can not get the return line too stop leaking. It has a new o ring and teflon seal. The hard line at the rack has a lot of up and down movement. Is there supposed to be a fitting in the rack that the hose end threads into?

  2. #2

    Default

    Maybe.
    Mine used this.
    Lots of FREE F/Z info on my site.
    http://myzephyrs.com

  3. #3
    FEP Senior Member 4EYED85's Avatar
    Join Date
    Mar 2012
    Location
    Round Rock, Tx
    Posts
    707

    Default

    Is that a fitting to convert to the other style end? Where did you buy that one? I have a type 2 end, but every hose I look up is a type 1 end. I ordered a different hose with type 1 end.
    Thanks a lot.

  4. #4

    Default

    That fitting screws into the rack, and then the hose screws into the fitting.
    I called Cardone when my hoses would not fit the rack and they sent them to me.

    I have seen the fittings in the parts stores in the Help section.

    If your hose threads into your rack, maybe your O ring or Teflon gasket is shot.
    Lots of FREE F/Z info on my site.
    http://myzephyrs.com

  5. #5
    FEP Senior Member 4EYED85's Avatar
    Join Date
    Mar 2012
    Location
    Round Rock, Tx
    Posts
    707

    Default

    O ring and teflon are new and both thread and tighten into rack. The return line does not feel like it seats in the rack.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •