It's been a while since I posted lately, so I figured I just make a quick update. Whereas we've had a pretty easy winter here in Kansas so far, we've finally paid for it with brutal cold and snow the past couple of weeks. Progress has been slow for the most part. I installed a new thermostat and am waiting on some clips to reinstall my fan shroud. I'm still awaiting my new engine harness from FMR. It's killing me because this is the last piece of the puzzle before I can fire her up. I ordered ...
Well, the weather has been pretty mild here in Kansas so I've taken advantage and buttoned up a few things on the Twister. I feel more of a sense of urgency to get things done as the warm weather has me thinking about spring and getting the car out. I finished up the new Edelbrock Performer intake and carburetor installation. I also got the valve covers and breathers installed today as well. I adjusted a rocker that was being noisy, but we will see how she sounds once she fires up ...
Wow, it's hard to believe it's been a month since I've been on here, but that's the way holidays go in my household. We had an unusually warm day here which prompted me to get a couple of small things done on the Twister today. I managed to get the 8 pin engine harness connector spliced in and took care of a couple ground wires that were chewed up as well. The FMR 8 pin connector went in nicely. Here shortly I'm going to order the main engine harness as mine is toast. Once I deciphered ...
I've posted briefly about this, but perhaps if mentions of it are here and there, folks might run across the information and be prepared for the next go 'round. If you've been around a while, you likely noticed that the site has undergone some serious changes this year. We've had a rough ride with a less-than-ideal switch of hosts and some damaged databases. I took the opportunity to get started on some upgrades and do my best to learn a large number of things to make me a better ...
Well, found out you can only have ten pictures in any post. Need to split it up, I guess. Home made head liner- not bad for $10 worth of craft store vinyl. My solution to the GT40P plug wire problems. It is actually a cut to fit wire set for a Chevy- all 90 degree boots. Fit great. Even the ones that did not NEED the 90 degree boots still fit and look better, ...
Updated 07-06-2013 at 07:41 PM by brianj
Recent Comments
Connect With Us