FS - Misc Mustang Parts - Garage Cleanout NNJ

[Satanpez]

Taillight harness from 1990 Mustang GT. In very good condition w/ light bulbs. None of the wires going to the front connectors are cut they were carefully removed from the connectors. However the black ground wires coming off the bulbs have been cut. (They had to be) Those are easily spliced into a new system. Great for when updating the rear lights. $15 Shipped.

http://www.gtluke.com/satanpez/taillight.jpg

Taillights from a 1979 Mustang. Should fit 79-82. By no means car show perfect but the lenses are fine. $60 shipped

http://www.gtluke.com/satanpez/taillights1.jpg
http://www.gtluke.com/satanpez/taillights2.jpg
http://www.gtluke.com/satanpez/taillights3.jpg

Radiator supports. $15 shipped.

http://www.gtluke.com/satanpez/Rad.jpg

Steering Wheel. $5 plus shipping
http://www.gtluke.com/satanpez/wheel1.jpg


Shifter boot that bolts to the driveshaft tunnel on later T-5 cars. It came off of my 1990 Mustang. I modified it to fit with my console delete and then ended up going a different route. $12 shipped

http://www.gtluke.com/satanpez/boot.jpg

Fuel harness from 1990 Mustang. It's the harness that goes to the fuel pump and fuel sender. $12 shipped.

http://www.gtluke.com/satanpez/Fuel.jpg

Automatic pedal cluster with power brake pedal. Includes everything in the picture. The cluster is an '82. The brake pedal is a '90 power brake pedal from a manual car (it uses the smaller rubber pad). Will bolt into any 79-93. I painted one of the brackets with rustoleum for rust prevention since I'm anal. It wasn't rusting before painting. If you're converting from manual to power brakes you want/need this pedal. $60 shipped

http://www.gtluke.com/satanpez/cluster.jpg

8.8 stock rear cover. Includes all the bolts. No rust. $15 shipped

http://www.gtluke.com/satanpez/cover.jpg

-Steve in NJ

[RsStang1984]

you tak 12 shipped on the pump harness?

[Satanpez]

PM Sent.

[Satanpez]

Door panels gone.
Fuel Pump wiring - Sale Pending

-Steve in NJ

[Bossnutt]

pm sent

[jrflans@roadrunner.c]

Interested in the 1982 4 cyl emissions stuff.
Thanks
Rus

[Satanpez]

Emissions equipment has been sold. All else is still available.

-Steve

[Satanpez]

Parts updated.

-Steve in NJ

[Satanpez]

Exhaust has been sold.

-Steve in NJ

[Flash Gordan]

Still got the shifter boot? If so I'll come pick it up this weekend.

[Satanpez]

If you're referring to the rubber/metal boot that goes on the driveshaft tunnel, yes.

I should be around most of the weekend.

PM me and I'll give you a phone #.

-Steve

[Satanpez]

Added/Removed parts. Will trade parts for an undamaged rear swaybar.

-Steve in NJ

[Satanpez]

Updated. Strut Mounts.

-Steve in NJ

[Fearmont]

Would it be possible for you to measure the width on the radiator supports. The part that actually clamps down on the radiator. I bought a radiator for my 80 Fairmont and had to modify the supports as they were too narrow. I'm needing to put one on my 81 Zephyr SW now and thought the Mustang supports might be wider. Thanks

Phillip

[Fearmont]

Just need the width on the rounded portiion that fits down on the radiator. thanks

[Satanpez]

15/16 of an inch wide for the part that goes on top of the radiator. Let me know if that helps.

-Steve in NJ

[Fearmont]

Thanks for the quick reply. I'll get back with you in a little while, got to run to the Post Office right quick.

Phillip

[Satanpez]

5-7/8" end to end. Between the two parts where the rubber sits is 3-3/8"

-Steve in NJ

[Satanpez]

Updated with taillight harness.

[skeeb]

PM sent on the strut mounts.

[Satanpez]

Parts still available.

-Steve in NJ

[Ackman70]

PM Sent.

[Satanpez]

Onion Head Strut Mounts are now gone.

-Steve in NJ

[Satanpez]

Updated.

[Satanpez]

Added a few items today.

-Steve